Strikolith Design Micro is for interior application as a coloured decorative plaster.
On fully plastered surfaces that are ready for wallpapering;
Once the Strikolith Universal Primer has dried sufficiently, stir the Strikolith Design Micro intensively, thin white and/or light colours with max. 1% clean tap water. Apply Strikolith Design Micro fully covering in the grain and cut clean with a knife. Pretreat inside and outside corners, applying good coverage. After sufficient drying, the whole can be sanded using a fine scouring sponge.
On NOT fully plastered surfaces; (such as plaster blocks, lime-sandstone adhesive elements etc.)
Once the Strikolith Universal Primer has dried sufficiently, stir the Strikolith Design Micro intensively, thin white and/or light colours with max. 1% clean tap water. Apply Strikolith Design Micro fully covering in the grain and cut clean with a knife. Pretreat inside and outside corners, applying good coverage. Allow this first layer to dry for at least 12 hours. A second layer can be applied when the first layer has dried sufficiently. Again apply this second layer fully covering in the grain and cut clean with a knife. After sufficient drying, the whole can be sanded using a fine scouring sponge.
Uw bericht
is succesvol verzonden
wij nemen zo spoedig contact met u op!
Advice needed?
Our customer service is ready for you.
Call +31 (0)162 – 51 47 50 or send an email via:
mail to infocenter@strikolith.com